![]() Not as light as trail boss, but it takes a sizable amount to hit 8 grains. But Hodgen's website specifically lists this load, and the 10 rounds I shot were very consistent. I bought some trail boss and will give it a try. I have been told I should use Trail boss because the CLAYS can be position sensitive. While this might not be the case with Clays (never used it) I know that there are some powders, mostly pistol, that require this and I tend to stay away from them for subsonic rifle loads. Is the Clays powder position sensitive? I know that some powders don't fill up enough of the case volume and tilting the rifle up before firing is needed to ensure full and correct powder burn. ![]() I don't need an M1A, I don't need an M1A, I don't need an M1A. I have loaded up 20 more to check them out. And I only shot the 10 shots I shot at 25 yards. But I don't have a range longer than 50 yards to check for keyholing. I have run 170 grain bullets with 8 grains of CLAYS through my M1A Scout and YHM phantom 7.62. super gap has narrowed in the past few months, so if you haven't played around with the EBR, it's a real treat.Īll this said, I'd call EBR and ask them - they're the ammo guys, let them know your twist rate and barrel length, and they should have the answers as to the right ammo from their catalog would be appropriate.ĪRFCOM INDUSTRY DISCLOSURE: twitter gemtweetch twitter garage sale vault moving spring cleaning twitter weekend hint I'll tell ya though, I recently got my first AK47 in fifteen years and it cycles sub EBR with an HVT mounted, which was a neat surprise. It didn't sound bad, probably just one of those "door dings" of life in the suppressor/reloading world, but squibs, unstable projos, low-speed deflagration, etc. I just had a gentleman call today asking what it might cost to repair an endcap strike that ensued in the pursuit of mixing up the perfect subsonic handloading. They've done the research and probably knocked the end out of a few suppressors on the R&D path leading to the best sub ammo currently available - if you want to play around and make your own loadings, I don't discourage it, but be aware of what you're getting into. ![]() In my opinion, EBR has it down better than anyone else. Mostly EBR with some Swiss, TTI, and non-commercial loadings. I've run a lot of subsonic through HVTs, TPRS, and some through the SANDSTORM cans, in both 7.62x39 as well as 7.62x51.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |